Fimap FM43 ORB Manual De Uso Y Mantenimiento página 34

Carefully cleaning the solution tank ensures the floor is cleaned
properly. Proceed as follows to clean the solution tank:
1. Take the appliance to the dedicated dirty water drainage area.
ATTENTION: The place this operation is carried out should
comply with current environmental protection regulations.
2. Check that the plug (1) on the power cable (2) has been taken out
of the socket (3) of the mains supply(Fig.1), and if not, disconnect
it.
1
4. Uncouple the solution tank tap tie chain (5) in the coupling in the
tap control handle (6) (Fig.4).
5. Remove the water distribution pipe (7) in the hole on the brush
head (8) (Fig.5).
6. Loosen the closing knob (9) (Fig.6) and position the top brackets
more than halfway up the column.
6
5
4
7
To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
• Pad holders or brushes
• Electric and electronic parts*
• Plastic parts
• Metallic parts
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
CHECKING AND CLEANING THE SOLUTION TANK (OPTIONAL)
3
1
2
2
8
5
10
DISPOSAL
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
3. Fix the handlebar in a position of about 45° to the ground, press
the uncoupling lever (4) (Fig.2) and turn the handlebar into
position (Fig.3). When the handlebar is in position, release the
uncoupling lever (4).
4
3
7. Remove the solution tank from the control column.
8. Remove the solution tank cap (10) (Fig.7).
9. Rinse the inside with a jet of water, if necessary use a spatula
to remove the sludge that has accumulated at the bottom of the
tank.
10. Repeat the operations in reverse order to reassemble all the
parts.
7
9
6
31