Publicidad
Idiomas disponibles
Idiomas disponibles
The required stroke rate can be preselected (also during
operation) using the wheel C.
§
If the tool does not run with wheel C in position 1,
select a higher sawing speed and lower the sawing
speed while the tool runs.
The required stroke rate is dependent on the material and
the working conditions and can be determined by a
practical trial.
After working for longer periods at low stroke rate allow the
machine to cool down by running it at maximum stroke rate
and no-load for approx. 3 minutes.
Use
MOUNTING OF SAW BLADE (FIGURE 4)
§
Only allow the jig saw to run with a jig saw blade
inserted.
Removes the screw of support D and loosens the screw of
setting of saw blade E. Insert saw blade F into slot in
support with teeth facing forward and press the screw of
setting of the saw blade E.
§
Insert blade to full depth with teeth facing forward
(figure 5).
To remove the blade for replacement reverse the procedure
ADJUSTAMENT THE BASE PLATE (FIGURE 6)
The semi-circle G on base plate H (is marked 15°, 30° and
45° which denote the cutting angles most commonly used.
Loose screw I, move the base plate H to the desired angle,
and retighten screw I.
Accessory*
DUST SUCTION (FIGURE 8)
When using tool with/without vacuum cleaner, mount
vacuum cleaner adaptor J as illustrated.
§
Do not use vacuum cleaner when sanding metal.
* The accessories illustrated or described are not
included as standard delivery.
Operating the tool
Before switching on the tool, ensure that front end of
footplate rests flat on the workpiece
Hold tool firmly with both hands, so you will have full control
of the tool at all times.
Ensure that complete surface of footplate rests firmly on the
workpiece.
Ensure that the blade has come to a complete standstill,
before you lift the tool from the workpiece.
Application advice
Move the tool in straight movements in line with the grain
Use the appropriate saw blades
§
Use T-shank blades only.
When cutting metals, lubricate saw blade regularly with oil
For an accurate straight cut, guide tool with footplate along
the edge of a straight piece of wood (figure 10).
Pre-drill a hole before making cut-outs (figure 11).
SPLINTER-FREE CUTTING
§
cover cutting-line with several layers of wide tape before
cutting.
§
always face the good side of the workpiece down.
For more tips see www.skileurope.com
Maintenance
§
Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the machine and
the ventilation slots clean.
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair should be
carried out by an authorized customer services center for
SKIL Power Tools
Guarantee
We guarantee SKIL appliances in accordance with
Statutory/country-specific regulations (proof of purchase by
invoice or delivery note).
Damage attributable to normal wear and tear, overload or
improper handling will be excluded from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the SKIL Service Center
for Electric Power Tools.
Warning!
Freight and insurance costs are charged to the client, even
for warranty claims.
Environmental protection
Recycle raw materials instead of disposing as waste.
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
The plastic components are labeled for categorized
recycling.
Subject to change without notice
14
Publicidad
