Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
16. Turn on hot and cold valves (L & R), check all
connections for leaks. Repair if needed.
17. Install the handles (A & E) and handle trim
rings (F) onto hot and cold valves (L & R).
Tighten set screws with hex wrench (BB),
replace caps.
18. With the valves in the closed position, remove
spout rough in cap (U) and wrap a rag around
the test plug (T) to prevent water spray. Carefully
remove the test plug (T) from spout base (M).
Warning: Water may purge from spout base (M)
when removing the test plug (T).
16
16
17
17
1
17-1
18
18
M
9
17-2
A
F
L
1
R
U
T
1
3
1
Publicidad
