Publicidad
Idiomas disponibles
Idiomas disponibles
3.- Flip the box upside down to allow the heater to stand on its feet and remove the carton. Please check that it is the correct
model and is in good conditions.
Check that all parts have been delivered and are intact.
-
1 Ecombi ARC heater casing.
-
1 Bag containing 2 screws, 2 rawl plugs, 4 white screws.
-
2 supporting feet.
-
1 top fixing plate.
-
2 side fixing plates.
-
This guide.
The casing and storage bricks are supplied separately. Check the supplied
bricks packages correspond to the ones indicated on the heater carton.
The heater operation is not affected if bricks with minor damage are used.
4.- Screw on the wall the top fixing plate, making the two required drills at the recommended distance depending on the model.
Use the rawl plugs and screws contained in the plastic bag to fix the fitting to the wall.
5.- Fix the side fixing plates to the metal casing by using the appropriate screws. The supply cables must be fitted but not wired to
the storage heater before placing the heater to the wall. Remove the white screws located in the top of ECO ARC, and place the
ECO ARC in the selected installation area. Use the removed screws to attach ECO ARC to the top fixing plate installed in the
wall.
ECO ARC MUST NOT BE HUNG ON THE SCREWS; these are used
only to prevent the device from overturning and not to support it. If there
is any doubt concerning the wall strength, consult the corresponding
construction specialist. The appliances are heavy; it is the installer
responsibility the correct installation and wall support of these devices to
prevent them from overturning.
16
Publicidad
