Publicidad
Idiomas disponibles
Idiomas disponibles
6.- Take off the front outlet grill by removing the four screws. Take off the front panel by removing the two screws located at the
bottom.
7.- Wire correctly the heater connecting Line, Neutral and Earth in the corresponding screw of the connection block. Tighten
properly the connection block screws. Do not leave any remaining wire inside the heater.
WARNING Touching live connections can cause serious personal injury.
8.- Unscrew the inner panel and remove it.
WARNING Steel edges can cut.
WARNING In the interior part of this inner panel there is a very delicate MICROTHERM insulation panel. It has to be handled
with extreme care. AVOID TOUCHING OR BENDING IT.
9.- Do not disconnect the electrical heating elements. Remove the packing cardboard and the metallic plate. Lift and tilt the
elements outwards being careful not to damage the insulation on the bottom of the heater and carefully place the storage bricks.
Arrange two levels of bricks with the flat side facing to the back of the heater.
17
Publicidad
