Installation Of Software - Singer XL-420 Manual De Instrucciones

INSTALLATION OF SOFTWARE

In order to start using the software on your PC you must first
install the contents of the CD to your PC. This procedure is
refered to as "installation procedure". Please follow the
instructions below in order to successfully install the
software for your FUTURA sewing & embroidery machine
on your personal computer.
The software for your FUTURA sewing & embroidery machine
comes on a CD-ROM disc.
In most personal computers the default drive setting for a
CD-ROM drive is "D:"
CD-ROM
Please insert the installation software for your FUTURA
sewing & embroidery machine into the CD-ROM disc receiver
in your PC.
After some seconds, the Installation procedure of the software
will start automatically.
If after a short while, the software doesn't automatically
start the installation process, you may start the installation
procedure manually by going to the "Start" option of Windows,
select "Run", type "D:\FuturaStart.exe" and click on OK.
After some seconds the step-by-step installation of the
software begins with the Welcome window.
Click on "Next" to move on to the next screen.
After reading and agreeing with terms given in the
License Agreement, please click on "Yes", and again click
on Next, and then select the directory where the software
should be installed. It is highly recommended to use the
selected default directory.
Simply click on "Next" to continue.
72