Publicidad
Idiomas disponibles
Idiomas disponibles
1. Make sure that the propane tank is tightly held
in position by the lock and the holder plate. The
propane tank cannot move when the propane tank
is correctly installed.
2. Connect the propane hose from the product to the
propane tank.
3. Make sure that the propane hose is correctly
connected to the fuel valve on the engine.
4. Make sure the all couplers are in line. Tighten the
couplers by hand to connect the propane tank to the
product.
CAUTION:
complete the connection of the propane
tank to the product. The couplers can
become damaged.
5. Turn the propane tank valve counterclockwise until it
stops to start the flow of the propane.
6. Do a soap test on all propane lines. Refer to
examine the propane tank and lines on page 15 .
7. Disconnect in the opposite sequence.
To change the position of the wheels
The wheels can have 2 positions in the frame. The top
hole (A) is used during standard grinding and polishing
operation. The top hole is also used for the accessories
PCD (Poly Crystalline Diamond) or bush hammer tools.
The lowest hole (B) is used for the accessory star wheel
cutter.
WARNING:
flat surface when you adjust height of the
wheels.
12
Do not use a tool to
To
The product must be on
1. Put the product in transport position. Refer to
the product in transport position on page 21 .
2. Lift the product of the ground. Refer to
product on page 21 .
3. Remove the bolts, the washers and the wheel from
the frame.
4. Install in the opposite sequence in the correct hole in
the frame.
5. Do the same procedure on the opposite side of the
product.
CAUTION:
wheels are put to the same height.
Operation speed
If the product is operated on a new surface type, set
the speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
To start the product
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Connect the dust extractor hose to the product.
To connect a dust extractor on page 9 .
Refer to
2. Start the dust extractor.
3. Connect the propane tank. Refer to
disconnect the propane tank on page 11 .
4. Stay behind the product and hold the handlebar with
your hands.
A
B
To set
To lift the
Make sure that the
Move the product all the
To connect and
1991 - 001 - 02.06.2023
Publicidad
