Publicidad
Idiomas disponibles
Idiomas disponibles
Hold the RFID card
„
The following image will be displayed on the digital charging display
„
Access authorisation with RFID card
„
Exit basic settings:
Put the basic settings cover
„
Screw the basic settings cover
„
side of the EV charger
Using the cover detect switch
„
exits the basic settings display.
z Using the device
PLEASE NOTE: If the charge current is too high, the connection cable may be damaged and this
could result in a fi re. Please note the information for your state and abide by the max.
permissible charge current.
If required, the emergency stop switch
on the digital charging display. You can go back to the original state by rotating the emergency stop
switch
clockwise a little.
5
Start the charging process:
Completely unwind the electric car connection cable
„
The digital charging display
„
The LED strip
lights up white and indicates that charging is not taking place.
4
Remove the protective cap
„
Plug the plug
into the car.
„
8
The digital charging display
18
GB/IE/NI/CY/MT
over the symbol
for a moment.
44
6a
is now permanently activated.
44
in place.
35
back on using the 4 screws for the basic settings cover
35
.
1
, the device detects that the basic settings cover
38
can be pressed at any time. "STOP" will be displayed in red
5
indicates that a car is not yet connected:
3
from the plug
9
indicates that a car is connected:
3
.
7
on the car side.
8
:
3
on the
36
is in position and
35
Publicidad
