ULTIMATE SPEED USWB 11 A2 Instrucciones De Funcionamiento Y De Seguridad página 20

The LED strip continually lights up in a circle and this indicates that current is fl owing into the car.
4
Otherwise the charging process will start at the time programmed in the car. In this case, the digital
charging display indicates that a car is connected:
3
The LED strip continues to light up white.
4
Some cars carry out a test charge fi rst for a few seconds. In this case, the digital charging display
indicates that the EV charger
Other cars take a very low charge current, before the actual charging at the time programmed in the
car. In this case, the digital charging display
The LED strip continually lights up in a circle and this indicates that current is fl owing into the car
4
(however this is roughly zero).
The digital charging display
capacity .
15
The display of the supplied energy resembles an electricity meter. However the value is not stored and
must be read out after each charging procedure.
Finish the charging process and disconnect from the vehicle:
The charging process will stop automatically at the time programmed in the car. The digital charging
display indicates that the charging process is complete:
3
The LED strip lights up fully in green.
4
If the charging timer in the car is deactivated, then fi nish the charging process in the car.
The charging process will be stopped. The digital charging display
process is complete:
The LED strip continues to light up white.
4
20
GB/IE/NI/CY/MT
is ready to charge at the time programmed in the car:
1
already indicates that the car is being charged:
3
shows the charging time
3
, the energy supplied
13
indicates that the charging
3
3
, and the charging
14