Sony CMT-T1 Manual De Instrucciones página 19

To cancel the timer
Press TIMER SELECT repeatedly until
"OFF" appears in the display instead of
"REC".
To set the timer with the same items
Press TIMER SELECT to display "REC",
and press POWER to turn off the system.
Once you set the timer, you do not have to
set the same items again.
To check the timer settings
Press TIMER SELECT until "REC"
disappears and appears in the display
again.
The preset items appear sequentially.
To change timer settings
Repeat steps 1 to 10.
Connecting Optional
Equipment
Connecting an MD, DAT
deck, etc.
To make a digital recording with an
MD, DAT deck, etc.
Connect the DIGITAL (OPTICAL)
OUTPUT jack on the rear panel of the tuner
CD player to a recorder, deck, etc. that has
an optical connector.
to digital
input jack
MD/DAT
deck
Digital cable POC-15A
(not supplied), etc.
To make an analog recording with an
MD, DAT, VCR deck, etc.
Connect the MD IN/OUT jacks (phono
jacks) on the rear panel of the stereo to an
MD, DAT, VCR deck, etc. with the Sony
RK-C315 connecting cord (not supplied).
Connecting cord RK-C315
(not supplied), etc.
to the
input jacks
MD/DAT/
VCR deck
to the output
jacks
To hear the VCR sound through the
connected speakers, connect the MD IN
jacks on the rear panel of the stereo to the
output jacks on the VCR. In this case,
connect the plugs to jacks of the same
colours.
For details, see the instruction manual for
each equipment.
To listen to the sound of the
connected equipment
Press FUNCTION repeatedly until "MD"
appears in the display.
Connecting an External
Aerial
To improve the FM reception
Connect an external aerial when the signal
reception is too weak with the supplied FM
lead aerial.
Connect an external FM aerial to the FM 75
Ω terminal, using a 75-ohm coaxial cable.
To improve the AM reception
Connect an external aerial if the signal
reception is too weak after reorienting the
Tuner CD
player supplied AM loop aerial. Do not
disconnect the AM loop aerial.
Connect a 6- to 15-meter insulated wire (not
supplied) to the AM terminal and extend
CD OPTICAL
the other end horizontally at a higher place.
DIGITAL OUT
Connect the y terminal to the earth.
Important
Earth the external aerial against lightning. To
avoid a gas explosion, do not connect the earth
wire to a gas pipe.
Insulated wire
(not supplied)
Earth wire
(not supplied)
Tuner CD
player
Chapter 6: Additional Features
EN
19