stayer FH730 Manual De Instrucciones página 25

→ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
→ Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
→ Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
2.- Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
2.1.- Intended Use
The machine is intended for cutting, roughing,
and brushing metal and stone materials without
using water.
With approved sanding tools, the machine can
be used for sanding with sanding discs.
2.2.- Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Release screw for protection guard
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protection guard for sanding
7 Mounting flange
8 Grinding/cutting disc
9 Clamping nut
ENGLISH
23
2.3.- Noise/Vibration Information
Notes on the details on page 1.
We reserve the right to undertake modifications to
reflect technical advances.
D = maximum grinding disc diameter
max
n = no-load speed
M = spindle thread
P = rated input
1
a = typically rated acceleration in the
hw
hand-arm area
Typical A-rated acoustic level:
L = acoustic pressure level
PA
L = acoustic power level
WA
During peration, the acoustic level may
exceed 85 dB(A).
Wear ear protectors!
m = Mass
Measures values established according to
EN 60745.
The stated technical specfications are subject to
tolerances (as specified in the respective current
standarsd.)
2.4.- Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745-2-3 accord-
ing to the provisions of the directives 2006/42/EC,
2004/108/EC, 2006/95/EC
3.- Assembly
3.1.- Mounting the Protective Devices
→
Before any work on the machine itself, pull
the mains plug.
Protection Guard for Sanding
Place the protection guard 6 onto the spindle
collar of the machine until the encoding keys of
the protection guard agree with the spindle col-
lar. Press and hold the release screw 1 while do-
ing this.
23
Ramiro de la Fuente
Director Manager