Key Auto Setup - Kicker KEY200.4 Manual Del Propietário

KEY Auto Setup

The KEY Activation Button is a multi-function button
attached to the included microphone that will begin
the Auto Setup process, toggle between Auto Setup
optimized audio and the original audio once the Auto
Setup process has been completed, or clear previous
Auto Setup settings.
The Auto Setup consists of several tune-up steps
including individual speaker equalization, KICKER EQ,
time delay and speaker sensitivity matching. If a setting
is defeated with the DIP switches on the KEY panel,
the settings will be registered in memory and can be
applied or cleared. Changing the DIP switch positions
does not require a new Auto Setup to be run.
Make sure active noise cancellation and active
noise enhanced are disabled beforehand. You will
need to load a source for pink noise from your head
unit, whether CD, MP3, AUX, Bluetooth, USB etc.
Uncompressed audio is recommended for best results,
as this will ensure full amplitude across the frequency
spectrum (20Hz–20kHz). Visit www.kicker.com/tech
to download the pink noise profile best suited for your
listening habits!
1. Set the KEY amplifier gains (AMP-1 and AMP-2) to
the minimum (fully counter-clockwise). Place all settings
in the signal chain, such as the EQ on your head
unit, to disabled or flat. Disconnect any speakers or
subwoofers not connected to the KEY amplifier, factory
or aftermarket.
English 14