Hillyard Trident WD21V Manual De Uso página 27

3.Bring the front squeegee to its resting position by lightly pressing downwards on the squeegee
command pedal (1) then moving it to the right just enough to hook it up to its restraint.
ATTENTION: you are advised to always
wear protective gloves, to avoid the risk of
serious injury to your hands.
4.Remove the vacuum hose (2) of the squeegee from the relative joint (3) of the vacuum nozzle.
5.Loosen the handwheel (4) of the right-hand pin (5) on the squeegee.
6.Repeat the same operation also for the left pin.
7.Remove the squeegee from its support.
8.Thoroughly clean the rear rubber blades (6) of the squeegee, first with a jet of water and then
with a damp cloth.
9.Check the state of wear of the rubber blades (6) of the squeegee. If the blade edge in contact
with the floor is worn, replace it - read "REPLACING THE RUBBER BLADES OF THE FRONT
SQUEEGEE (OPTIONAL)".
10.Thoroughly clean the vacuum chamber of the squeegee, first with a jet of water and then with a
damp cloth.
27