Replacing The Rubber Blades Of The Front Squeegee (Op) - Hillyard Trident WD21V Manual De Uso

REPLACING THE RUBBER BLADES OF THE FRONT SQUEEGEE (OPTIONAL) WD21V
The good operation of the whole vacuum unit ensures better drying and cleaning of the floor, as
well as a longer vacuum motor life. To replace the squeegee rubbers, proceed as follows:
1.Take the machine to the maintenance area.
2.Make sure the machine is in a safe condition (read "MACHINE SAFETY").
3.Bring the front squeegee to its resting position by lightly pressing downwards on the squeegee
command pedal (1) then moving it to the right just enough to hook it up to its restraint.
ATTENTION: you are advised to always
wear protective gloves, to avoid the risk of
serious injury to your hands.
4.Remove the vacuum hose (2) of the squeegee from the relative joint (3) of the vacuum nozzle.
5.Loosen the handwheel (4) of the right-hand pin (5) on the squeegee.
6.Repeat the same operation also for the left pin.
7.Remove the squeegee from its support.
38