Columbus AKS 70 VM 62 Manual De Instrucciones página 23

Vacuum sweeper
AKS 70|VM 62
Fig. 8:
1) Start lever
2) Accelerator lever
3) Filter buzzer button
4) Acoustic indicator button
5) Hourcounter
6) Working light switch (optional)
7) Ignition key
START LEVER:
Part. 1 It is needed for "cold" ignition of the machine. It is positioned in "up" position. After the ignition it must be slowly brought back.
ACCELERATOR LEVER:
Part. 2 It controls the number of motor's rotations.
FILTER BUZZER BUTTON:
Part. 3 This buzzer cleans the suction filters through a motor-vibrator Part. 2 Fig. 5; it must be pressed at least 6 / 7 times for 8 / 10 seconds
each (operation to be performed before starting work, before emptying the bin and with the motor off); to perform this operation with motor
running, close the suction by pulling the knob Part. 1 Fig. 6.
ACOUSTIC INDICATOR BUTTON:
Part. 4 By pressing this button the acoustic indicator switches on
HOURCOUNTER:
Part. 5 Makes it visible the number of hours worked by the machine.
WORKING LIGHT SWITCH: Optional
Part. 6 It activates the adjustable working light.
IGNITION KEY :
Part. 7 It activates the switchboard and in particular the movement potentiometer. It is therefore possible to move the machine without have
it working
CHAPTER 8 – OPERATOR WORK STATION AND EMERGENCY STOP
WORK STATION:
The work station is shown in Fig. 12.
IMPORTANT: For safety reasons, the machine switches off automatically if the operator moves from the driving seat or if the motor bonnet
EMERGENCY STOP:
Release the forwarding pedal and press the brake pedal Part. 4 Fig. 10, switch off the machine by turning off the key on the switchboard
(anticlockwise) Part. 7 Fig. 8
CHAPTER 9 – SAFETY REGULATIONS
 DEFINITION: These are risks which, for various reasons, cannot be eliminated. Please find below some indications on how operating in
total safety.

Risk of injury to the hands and eyes if the machine is used without all the safety protections properly fitted and in good working
condition.

Risk of injury to hands by touching the side brush or central brush for any reason during rotation. The brushes must only be touched with
the motor switched off and wearing protective gloves to avoid being pricked or cut in the event of sharp objects caught up between the
bristles.
STANDARD FEATURES AKS 70|VM 62
part. 3 fig. 3 is raised or is not completely closed.
OUTSTANDING RISKS WHICH CANNOT BE ELIMINATED
23