Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the remote controls
Press the „Up" button on the remote control. The screen
1.
will automatically move to the upper end position and stop
automatically.
2.
Press the „Stop" button on the remote. The movement of
the screen stops immediately.
Press the „Down" button on the remote control. The screen
3.
will automatically move to the lower end position and stop
automatically.
Pairing the radio remote control
The radio remote control is already paired with the integrated receiver at the
factory. If the pairing has been cancelled, please proceed as follows:
1.
The screen should be disconnected from the power supply. Open the
battery compartment of the radio remote control. There is a small button
to the left of the battery.
2.
Connect the screen to the power supply and immediately press the
button twice in quick succession. A signal tone will then sound twice.
3.
After the signal tone, press the „Up" button until the signal tone sounds 3
times in succession. This completes the pairing.
If the pairing between the remote control and the screen is broken, first re-
connect the remote control and then the trigger.
Trigger (cable)
The trigger connection allows the screen to extend and retract automatically
when the projector is switched on and off. To do this, connect the screen to the
trigger output of your projector via the trigger connection. The trigger output
of your projector may have to be activated in the software so that the projector
can send the control signals to the screen. For more information, please refer
to the operating instructions of your projector or contact the manufacturer.
Input voltage of the trigger connection: DC / AC 5V - DC / AC 20V
8
Publicidad
