MEGABRAS MD 5060x Manual De Uso página 12

4. Connecting the equipment
ATTENTION: For a safety operation the procedures detailed below
should be carried out with the device Powered-Off.
Check if there is no differences of potential voltage between the points
where the equipment shall will be connected to, nor between them and
the ground.
Connect the red security terminal (red cable) to the insulation tester (-V)
output terminal. Connect BNC terminal to the zero reference (+R) terminal
and the "alligators" terminals to the element to be measured as indicated
in the figure below.
RED TEST LEAD
BLACK TEST LEAD
The test leads in the picture are illustrative.
13