MEGABRAS MD 5060x Manual De Uso página 17

The test result is calculated according to the following formula:
After test ending, the value may be recovered by pressing
5.2.3. "Pass / Fail" Test mode
Press key in order to determine the lower insulation limit for type
"Pass / Fail test". Select this value using
values are 10 M , 100 M , 1 G or 10 G .
During a "Pass/ Fail test", the MD-5060x will indicate when the insulation
resistance is lower than the programmed limit, with an intermittent beep
and the key led flashing. The
end of tests, or until the measurement of the resistance value is greater
than the programmed limit.
R
=
SVT
V MAX
R
500
key led will remain flashing until the
18
key.
and keys. Possible