Braun Aesculap Acculan 3Ti Instrucciones De Manejo/Descripción Técnica página 21

Mechanical alkaline cleaning and thermal disinfection
Machine type: single-chamber cleaning/disinfecting machine without ultrasound
Phase Step
I Pre-rinse
II Cleaning
III Intermediate rinse
IV Thermal disinfection 90/194
V Drying
D–W: Drinking water
FD–W: Fully desalinated water (demineralized, microbiological, at least of drinking water quality)
*Recommended: BBraun Helimatic Cleaner alcaline
►
Insert the product in its proper position in the
ECCOS fixation.
►
Screw the rinsing adapter (GA672211) on the prod-
uct in the mount 17.
►
Then connect the interior rinse device and connect
to the rinse connector of the cleaning/disinfection
device/rinse cart.
►
Attach the Kirschner wire protection sleeve 15 to a
rinse hose.
►
After automatic cleaning/disinfection, check visible
surfaces for residues and repeat the cleaning/disin-
fection process as needed.
6.8 Inspection, maintenance and
checks
►
Allow the product to cool down to room tempera-
ture.
►
Inspect the product after each cleaning and disin-
fecting cycle to be sure it is: clean, functional, and
undamaged.
►
Spray product after every cleaning and disinfection
with oil spray adapter GB600840 (black) approx.
2 sec with Aesculap STERILIT-Power-Systems
GB600 oil spray, see Fig. 13.
D t
[°C/°F] [min]
<25/77 3
55/131 10
> 10/50 1
5
- -
Water Chemistry/Note
quality
D–W -
■
FD–W
Concentrate, alkaline:
– pH ~ 13
– <5 % anionic surfactant
■
working solution 0.5 %
– pH ~ 11*
FD–W -
FD–W -
- mind. 10 min at max. 120 °C
Fig. 13
Note
Aesculap additionally recommends occasional spraying
of moving parts (such as knobs, couplings, cover lids)
with the Aesculap STERILIT-Power-Systems oil spray.
►
Check the product for any damage, abnormal run-
ning noise, overheating or excessive vibration.
►
Set aside the product if it is damaged.
en
19