Hilti PM 20-CG Manual De Instrucciones Original página 28

1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols can be used on the product:
The product supports near-field communication (NFC) technology compatible with iOS and
Android platforms.
Li-ion battery
Never use the battery as a striking tool.
Do not drop the battery. Never use a battery that has suffered an impact or is damaged in any
other way.
Hilti Li-ion battery type series used. Observe the information given in the section headed In-
tended use.
If applied on the product, the product has been certified by this certification body for the US and
Canadian markets according to the applicable standards.
1.4 Laser information on the product
Laser information
1.5 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Combilaser
Generation
Serial no.
1.6 Declaration of conformity
The manufacturer declares, on his sole responsibility, that the product described here complies with the
applicable legislation and standards.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 Safety
2.1 General safety instructions, measuring tools
WARNING! Read all safety precautions and other instructions. Measuring tools can present hazards
if handled incorrectly. Failure to observe the safety instructions and other instructions can result in damage
to the measuring tool and/or serious injury.
Keep all safety precautions and instructions for future reference.
Work area safety
▶ Keep your workplace clean and well lit. Cluttered or poorly lit workplaces invite accidents.
24 English
Laser class 2 based on standard IEC / EN 60825-1:2014 and corresponding
to CFR 21 § 1040 (Laser Notice 56).
Do not look straight into the laser beam.
PM 20­CG
PM 20­CG A12
PM 20­CGE
01
2328447
*2328447*