Hilti PM 20-CG Manual De Instrucciones Original página 35

3. Check that the battery is seated securely.
5.3 Removing the battery
PM 20­CG A12
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Inserting/changing batteries
PM 20­CG
PM 20­CGE
• Make sure that battery polarity is correct.
• Changes all the batteries at the same time.
• Use only batteries that have been manufactured in accordance with international standards.
1. Flip the battery compartment open.
2. Remove the spent batteries, if applicable.
3. Insert the new batteries.
4. Close the battery compartment.
5.5 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti anti-fall cable recommended for your product.
▶ Prior to each use, always check the anti-fall cable and the attachment points of the anti-fall cable for
possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti PMA 92 anti-fall cable.
▶ Secure the anti-fall cable to the laser and to a load-bearing structure. Check that it holds securely.
Comply with the operating instructions of the Hilti anti-fall cable.
*2328447*
2328447 English 31