Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
4. From below, slide lower sprayer gun holder (B) tabs
into slots on bottom left side of power washer unit (D).
5. Hold back the collar at one end of the end of the hose
(H). Push firmly to connect hose fitting to the water
outlet tube on the front of the power washer unit (D).
Twist the collar clockwise to secure. Confirm hose is
locked into the water outlet by slightly pulling on the
hose.
Note: DO NOT use pliers or locking pliers to tighten.
6. Hold back the collar at the other end of the hose (H).
Push firmly to connect hose fitting to spray gun (I). Twist
collar clockwise to secure. Confirm hose is locked into
spray gun by slightly pulling on them.
8 | Westinghouse Outdoor Power Equipment, LLC
Publicidad
