Control Panel; Wall Mounting The Control Panel - AERMEC RePuro 100 Manual De Instalación

12.

CONTROL PANEL

12.1.

WALL MOUNTING THE CONTROL PANEL

The AERMEC RePuro units are controlled by the user through a wired wall mounted control panel. The control panel has an espe-
cially low profile design (12 mm) and can be mounted over a recessed electrical wall box.
The wired control panel has to be connected to the RePuro unit using the cable supplied loose. The cable length supplied is 6
metres long. However, if a longer cable is required (not provided) then this must have the same characteristics as the cable sup-
plied loose (screened 4 core cable)and must have a MAXIMUM length of 30 metres.
The functions necessary to install the control panel of the RePuro unit are:
Once the unit is positioned pass the four core cable
1 through the provided aperture up to the wall box (the
relationship between the wall mounted panel and the
recessed wall box is shown in the following paragraph)
on top of which the control panel will be mounted.
Power cable length = 2m
The power cable provid-
ed with the unit is fitted
with a Schuko plug
If the installation requires the removal of the terminal block on the cable from the unit pay particular attention to the con-
nection sequence of the cables and terminals which must not be changed.
Follow RIGOROUSLY the cable/terminal relationship detailed in the table below:
Terminal
Colour
VMF-E4
Brown
Green
Yellow
White
Legend:
A = 4 core screened cable for connection
B = Screen folded over for connection to earth
C = Plastic terminal with conductor fixed to the metal structure of the RePuro
D = Cores to connect to the interface terminal of the thermostat board
30
IREPLJ - 1302 - 4238060_02
1
2
3
4
1
2
3 4
WARNING: If this operation requires the removal of the
terminal block on the cable from the unit pay particular
attention to the connection sequence of the cables and
terminals which must not be changed.
The wired connecting cable for the wired
control panel is terminated with a 4 pole
Cable characteristics to use for
connection:
Connecting cable length = 6m
terminal block
RePuro