Nap Timer; Projection Function - Medion LIFE E66212 Manual De Instrucciones

8.2.6. Nap timer

You can set the device to wake you up with an alarm tone after a specified time
(00:01–23:59 hrs).
 Press the N A P /T I M E R button.
The NAP/Timer display 0:30 now begins to flash.
 Use the ▼- T U N I N G or T U N I N G -  button to set the desired time.
 Press the N A P /T I M E R button again to start the NAP timer.
The NAP symbol now appears on the display.
 Press the N A P /T I M E R button to pause the NAP timer.
 Press the N A P /T I M E R button again to resume the NAP timer.
Once the timer has expired, the alarm tone will sound even if the radio is switched
on.
 Hold down the N A P /T I M E R button to switch off the N A P / T I M E R func-
tion.

8.3. Projection function

The device has a projection function, which allows you to project the time onto a
level surface; for example, a wall.
It must be dark in the room for the projected time to be visible.
8.3.1. Setting up the projection arm
In order to fully use the projection arm, you must pull it out of the device. This is
done as follows:
1) Flip up the projection arm.
2) Pull the projection arm upwards until it clicks into place.
ES
EN
DE
45 of 74