Dremel 8220 Instrucciones De Funcionamiento Y Seguridad página 22

1600A01RP1.qxp_8220 4/16/19 3:01 PM Page 22
inside curves and other diffi cult places, and
other sanding jobs. You replace the sanding
bands on the drum as they become worn and
lose their grit. Bands come in fine medium
and coarse grades. Flapwheels grind and
polish flat or contoured surfaces. They are
used most effectively as a finishing sander
after heavier surface sanding and material
removal is completed. Flapwheels come in
fine and coarse grades. Buffs are a great
finishing accessory for cleaning and light
sanding. They work effectively on metal,
glass, wood, aluminum and plastics. Coarse
and medium buffs are sold together. All buffs
are sold individually. Do not exceed 15,000
RPM in speed. 1/8" shank.
Grinding Wheel
Use for deburring, removing rust, and general
purpose grinding. Use with Mandrel #402.
Cutting Wheels
These thin discs of emery or fiberglass are
used for slicing, cutting off and similar
operations. Use them for cutting off frozen
bolt heads and nuts, or to reslot a screw
head which has become so damaged that
the screwdriver won't work in it. Fine for
cutting BX cable, small rods, tubing, cable
and cutting rectangular holes in sheet metal.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall. Use
with Dremel No 565/566 Cutting Guide
attachment.
Dremel Accessories (Continued)
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and
plaster. Use with Dremel No 565/566 Cutting
Guide attachment.
Spiral Cutting Bit
Cuts through all types of wood and wood
composites. Use with Dremel No 565/566
Cutting Guide attachment.
High Speed Router Bits
For routing, inlaying, and mortising in wood
and other soft materials. Use with Dremel
No. 335 Router attachment and No. 231
Shaper/Router table.
Brad Point Drill Bits
Titanium coated brad points stay on center
and begin drilling immediately. For use on
wood. Size 1/8", 5/32", 3/16", ¼" . 1/8" shank.
HSS Drill Bits
HSS drill bit for use in metal and plastic. Size
1/8", 7/64", 3/32", 5/64", 1/16", 3/64", 1/32".
Shank size matches the drill bit size.
Different collet size (481, 482, 483) or
Dremel chuck (4486) required according to
drill bit being used.
22