Motorola Solutions IMPRES NNTN8845 Guia Del Usuario página 14

Manually Terminating Calibration/Reconditioning
At any time during IMPRES 2 or IMPRES battery discharge (Steady
Amber), Calibration/Reconditioning may be terminated by performing
the following steps:
1. Remove the battery from the charger pocket.
2. Within 5 seconds, reinsert the battery into the charger pocket.
Battery discharge immediately terminates, and normal battery charging
starts. The LED indicates Charge Status.
IMPRES 2 or IMPRES End-of-Service-Life LED Indication
The IMPRES 2 charger may indicate IMPRES 2 or IMPRES battery
End-of-Service (Alternating Red/Green) upon successful completion of
Calibration/Reconditioning.
As batteries are used, normal wear reduces available capacity. At the
successful completion of Calibration/Reconditioning, IMPRES 2 or
IMPRES chargers compare IMPRES 2 or IMPRES battery capacity to
the battery Rated Capacity. When the capacity is at a very low value,
the IMPRES 2 or IMPRES battery may be nearing its End of Service.
The IMPRES 2 or IMPRES battery remains usable. In some scenarios,
it may be desirable to deploy the battery to someone who does not
require large battery capacity to complete a work shift.
APX NEXT XN battery comes with high temperature detection feature
that is detectable from IMPRES 2 charger with software version V2.05
or newer. When this feature is enabled, the status LED flashes Red
and Green alternately upon charge completion for battery that went
through prolonged exposure under extreme high temperature
environment. It is recommended to remove this battery out from the
service.
12