Oase Aquarius Universal Classic 440 Instrucciones De Uso página 180

Installation and connection
The pump can be installed submerged (in water) or dry (outside the water).
The use of the pump is only permitted with observance of the specified water quality.
(→ Permissible water quality)
WARNING
Severe injuries or death due to operation of this unit in a swimming pond. Defective electrical
components will electrify the water with dangerous electrical voltage.
Never operate the unit in a swimming pond.

NOTE
If the pump is used for conveying excessively soiled water, the impeller unit will be subject to in-
creased wear and will require earlier replacement.
Thoroughly clean the pond or pool before installing the pump.

Install the pump at a raised level above the bottom. This reduces intake of muddy water.


Avoid direct sunlight on unit components that are not submerged, as they may overheat. If
necessary, use a protective cover.
Turning the pump inlet
The pump inlet can be moved to the required orientation.
Orientation
Top or side (right, left)
Bottom
20
Use
• Recommended for dry installation.
• When used with submerged installation, ensure that the water level is
sufficient.
• Recommended for submerged installation.
• Pumps water even when the water level is low.
ARS0075