Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTIONS
WARNING: To avoid possible electrical shock, be sure you have turned off the power
at the main circuit panel before wiring.
Follow the steps below to connect the fan to your household wiring. Use the wire
Mounting Bracket
connectors supplied with your fan. Secure the connector with electrical tape. Make
Receiver
sure there are no loose wire stands or connections.
WARNING: If your house wires are different colors than referenced in this manual,
stop immediately. A professional electrician is recommended to determine proper
wiring.
Step 1. Insert the receiver into the mounting bracket, with the flat side facing up toward
the ceiling. (Fig. 15)
Step 2. Connect wires using the connectors as shown in WIRE DIAGRAM. (Fig.16)
WARNING: Check to see that all connections are tight, including ground, and that no
bare wire is visible at the wire connections.
Fig. 15
Step 3. After the connections have been made, they should be turned upward and
pushed carefully up into the outlet box. The wires should be spread apart with the
grounded conductor (white wires) and the equipment-grounding conductor (green or
bare copper wires) on one side of the outlet box and the ungrounded conductor (black
wires) on the other side of the outlet box.
12 | KICHLER.COM
Publicidad
