Publicidad
Idiomas disponibles
Idiomas disponibles
HANGING THE FAN (continued)
Clevis Pin
Hairpin
Downrod
Step 4. Carefully feed fan wires and safety cable up through the
downrod. Thread the downrod onto the motor coupling until the clevis
Motor Coupling
pin holes are aligned. Next, replace the clevis pin and hairpin, then tighten
both set screws. (Fig. 10)
Step 5. Slip the coupling cover, canopy hole cover and canopy onto the
Set Screw
downrod. Carefully reinstall the hanger ball onto the downrod. Make sure
Fig. 10
the cross pin is in the correct position and the set screw is tight and the
wires are not twisted . ( Fig. 11)
CAUTION: Ensure all screws are tight before moving to the next step.
Hanger Ball
Set Screw
Canopy
Cross Pin
Canopy Hole Cover
Coupling Cover
Downrod
Fig.11
56" Almere | 9
Publicidad
