Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WALL CONTROL
Outlet Box
Switch
Wall Plate
WARNING: All wiring must be in accordance with the National Electrical Code and
local electrical codes. Electrical installation should be performed by a qualified
licensed electrician.
NOTE: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND NATIONAL
ELECTRIC CODE.
Fig. 17
WARNING: Shut off main power at the circuit breaker or fuse panel before continuing.
Step 1. Remove the existing wall plate and the old switch from the wall outlet box.
Disconnect wires. (Fig. 17)
Wall Control
Step 2. Connect the outlet box wires to the wall control wires, using the wire connectors
provided. (Fig. 18)
*Connect the lead wire (HOT) from the outlet box to BLACK wire marked
"AC IN L" from wall control.
Outlet Box
Face Plate
*Connect the lead wire (LOAD) from the outlet box to BLACK wire marked
HOT
"TO MOTOR L" from wall control.
*Connect the GROUND from the outlet box to GROUND from wall control.
Step 3. Secure the wires connectors and make sure there are no loose strands or
Fig. 18
connections. Carefully tuck wire connections back inside outlet box and secure the
wall control to outlet box with screws provided. Snap the face plate in place on the front
of the wall control.
14 | KICHLER.COM
Publicidad
