Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING THE FAN BLADES
CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The
Electrical Supply Circuit To The Fan Before Installing Fan Blades.
Step 1. Align the four holes in a blade with four matching holes in the
blade holder. Thread blade attachment screws into the aligned holes,
and tighten screws to secure the blade to the blade holder. Repeat for
remaining blades. (Fig. 5)
Step 2. NOTE: Inside of the blade holder there are six tabs. Three of the
tabs have a post on top, and three of the tabs have a hole in the center.
NOTE: In the outer ring of the motor assembly there are six holes. Three
of the holes are smaller in size and three of the holes are larger in size.
Carefully insert the motor assembly into the blade holder, aligning the
smaller holes in the motor assembly with the posts on top of the tabs.
Pass the posts through the smaller holes, and seat the outer ring of the
motor assembly on top of all six tabs.
The larger holes in the motor assembly should align with the holes in
the tabs. Thread the three motor assembly attachment screws into the
larger holes in the motor assembly and into the holes in the tabs, and
tighten to secure the motor assembly to the blade holder. (Fig. 6)"
Blade Holder
Blade
Motor Assembly
Attachment Screws
Motor Assembly
Tab With Post
Blade Attachment
Screws
Fig. 5
Tab With Hole
Blade Holder
Fig. 6
56" Almere | 7
Publicidad
