Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
ACTIVATING THE LEARNING PROCESS
NOTE: The control system for this fan is equipped with a learning frequency function which has 56K
Faceplate
LEARN
code combinations to prevent potential interference from other remote units. The frequency on your
receiver and wall control unit has been preset at the factory. No frequency change is necessary. If
the fan is non-functional or if you desire to install another fan within the same area with a separate
frequency code, follow the instructions below.
1.Use a small flat screw driver and gently pry the faceplate apart from the top of wall control. (Fig. 22)
2.After installation is complete, press and hold the LEARN button for 3 seconds within 30 seconds
after AC power is turned on. Fan will turn on at medium speed and light (if installed) will turn on. This
confirms that the SMART SYNC setting is active and OK.
3.If you cannot finish the setting within the 30 seconds time frame, the main power must be turned
Light function selection switch
off and re-started again. This will repeat step 1 until the LEARN feature is activated as indicated.
Fig. 22
LIGHT FUNCTION SELECTION SWITCH (Fig. 22)
D means "Dimmer"
O means "only on/off, no dimmer"
The light of this fan is dimmable, it has been set to "D" position at factory. If you want the light to be
only ON/OFF, slide the switch to "O" position.
NOTE: The "LIGHT FUNCTION SELECTION SWITCH" is N/A for this fan. This fan does not
include a light kit or lamps.
WALL CONTROL OPERATION(Fig. 23)
ON/OFF: Active and lock the wall control
HI : High speed
MED: Medium speed
LOW: Low speed
FAN OFF: Turn off the fan
LIGHT: Turn light ON or OFF. Press and hold the button to set desired brightness.
Fig. 23
NOTE: The "LIGHT" button is N/A for this fan. This fan does not include a light kit or lamps.
16 | KICHLER.COM
Publicidad
