Publicidad
Idiomas disponibles
Idiomas disponibles
Intended Use
The machine is intended for hammer drilling in
concrete, brick and stone as well as for light chis-
elling work. It is also suitable for drilling without
impact in wood, metal, ceramic and plastic.
Changing the Tool
Before any work on the machine itself, pull
the mains plug.
With the SDS-plus tool holder, simpler and easier
tool changing is possible without additional aids.
Grease the shank end of the tool regu-
larly.
The dust protection cap 1 largely prevents the
entry of drilling dust during operation. When in-
serting the tool, take care that the dust protection
cap 1 is not damaged.
A damaged dust protection cap should be
changed immediately. We recommend having
this carried out by an after-sales service.
As a requirement of the system, the
SDS-plus tool must rotate freely. At no-load
speed, this leads to a certain amount of ra-
dial run-out.
This does not affect the accuracy of the drill
hole, as the bit is automatically centred dur-
ing drilling.
Inserting (see figure
Clean and grease the shank end of the tool.
Insert the tool in a twisting manner into the tool
holder until it locks. Check if it has locked by pull-
ing the tool.
Removing (see figure
Push back the locking sleeve 2 of the tool holder
and remove the tool.
)
A
)
B
English - 2
Auxiliary Handle/Depth Stop
Use the machine only with the auxiliary
handle 7.
Loosen the handle by turning to the left. Rotate
the auxiliary handle 7 and adapt to the working
position.
Firmly retighten the handle.
The drilling depth can be set with the depth
stop 8.
For this, loosen wing bolt for depth stop adjust-
ment 6, set the required drilling depth X and
tighten the wing bolt again.
X
The ribbing on depth stop 8 must point upwards.
Initial Operation
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
To start the machine, press the On/Off switch 3
and keep it depressed.
To switch off the machine, release the On/Off
switch 3.
For
low
temperatures,
reaches the full hammer/impact perform-
ance only after a certain time.
This start-up time can be shortened by
striking the drill/chisel against the floor one
time.
6
the
machine
Publicidad
