Pur Line HEATY EX BLACK Manual Del Usuario página 15

INSPECTION ITEMS AFTER INSTALLATION
Items to check
Is the installation stable?
Is the thermal insulation adequate?
Is the supply voltage the same as indicated on the
product nameplate?
Is the cable connection correct?
Is the electrical grounding safe?
Does the wiring conform to the standard?
INSPECTION ITEMS FOR COMMISSIONING
1. Electricity must not be switched on before all installation work has been completed.
2. All wiring connections are correct and tight.
3. All scattered objects must be removed from the body of the radiant heater.
4. Switch on the power to observe the operating condition of the radiant heater.
OPERATION
USE
TURN ON:
Plug the appliance into a mains socket.
Turn the main switch to the on position "I".
REMOTE CONTROL
Situation caused by incorrect installation.
Equipment may fall down or shake.
Objects near the equipment are damaged.
Equipment failure.
Equipment failure.
Is there a risk of electrical leakage?
Equipment failure or circuit damage.
Press the on/off button to switch the appliance on or off.
P1 button: low heating power (600W)
P2 button: medium heating power (1200W)
P3 button: high heating power (1800W)
Timer button: 24 h timer.
13