Publicidad
Idiomas disponibles
Idiomas disponibles
Riving Knife
A removable metal piece of the blade guard assembly, slightly thinner than the saw blade, which helps
keep the kerf open and prevent kickback.
Height Adjusting Handlebar
Use this handlebar to lower and raise the blade for height adjustments or blade replacement.
Miter Gauge
The miter gauge aligns the wood for a cross cut. The easy-to-read indicator shows the exact angle for a
miter cut.
Rip Fence
A sturdy metal fence guides the workpiece.
3.2.
Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
3.3.
Assembling the device
The table saw comes partially assembled and is shipped in carefully packed carton. After all the parts have
been removed from the carton, there should be:
EN
Publicidad
