Publicidad
Idiomas disponibles
Idiomas disponibles
Rear Bench Extension
1. Align the rear bench extension flush with the saw bench.
2. Pushing the rear extension onto the sawing bench using bolts M6×12 and loosely fasten the flat
washers and nuts M6.
3. Screw the long support struts to the bench extension and short centre brace with bolts M6×12,
washers 6 and nuts M6.
4. Tight the bolts and nuts slightly by hand.
5. Fasten the wheel assembly to the rear base legs using four hexagon bolts M6×12, washers 6, and nuts
M6. Tighten all the bolts and nuts slightly by hand.
EN
A – Transporting Wheels
B – Long Support Strut
C – Height Adjustment Handlebar
D – Bench Extension
Publicidad
