Publicidad
Idiomas disponibles
Idiomas disponibles
EN
A – Rip Fence
For illustrations 1, 2, 3 and 4 above:
3.4.
Device use
3.4.1.
Set Up
Change Blade Depth
Turn the height adjusting handlebar to set the blade to the required cutting depth.
Counterclockwise: smaller cutting depth
Clockwise: larger cutting depth After each new adjustment it is advisable to carry out a trial cut in order to
check the set dimensions.
Change Blade Angle
Unplug the saw.
Loosen the bevel limitation screws in both sides of chip box.
Set the desired angle on the scale by pressing and turning the chip box.
Tighten the bevel limitation in the required angle position.
Publicidad
