Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4. Guide at the side with your left or right hand (depending on the position of the rip fence) only as far as
the front edge of the saw blade guard.
5. Always push the workpiece through to the end of the riving knife.
6. The offcut piece remains on the saw blade until the blade back in its position of rest.
7. Secure long workpiece against falling off at the end of the cut.
Cutting Narrow Workpieces
Be sure to use a push stick when making longitudinal cuts in workpieces smaller than 120 mm in width. A
push stick is supplied with the saw. Replace a damaged or worn push stick immediately.
1. Adjust the rip fence to the width of workpiece you require.
2. Feed in the workpiece with two hands. Always use the push stick in the area of the saw blade.
3. Always push the workpiece through to the end of the riving knife.
Warning! With short workpiece, use the push stick from the beginning.
Publicidad
