Publicidad
Idiomas disponibles
Idiomas disponibles
Support Legs & Long / Short Centre Braces
1. Turn the saw and place it on the floor with the bench facing down.
2. Fasten the four base legs onto the bench. See illustration 1 & 2, only need to assemble one bolt,
washer and nut in each leg. See illustration 3, need two bolts, two washers and two nuts for each leg.
Tighten the bolts slightly by hand.
3. Screw the long centre braces and the short centre braces onto the base legs using the bolts M6×12,
washers 6 and nuts M6. Tighten the bolts slightly by hand. Make sure that the same braces face each
other. The short centre braces must be mounted parallel to the operator's side of the saw.
4. Attach the four rubber feet onto the base legs.
EN
A – Short Centre Brace
B – Long Centre Brace
C – Rubber Foot
D – Crank (working Area)
E - Leg
Publicidad
