Publicidad
Idiomas disponibles
Idiomas disponibles
8. Remove the riving knife by loosening the clamp bolt in the clamping plate by turning it clockwise a few
revolutions and then pulling the riving knife up and out. See below illustration 4.
9. Attach the ring spanner to the fixing bolt. See below illustration 5.
10. Fasten the blade flange with the saw blade key. See below illustration 5.
11. Turn the fixing bolt in an anti-clockwise direction using the ring spanner.
12. Carefully hold the saw blade with one hand and remove the fixing bolt and the outer saw blade flange
from the drive shaft.
13. Now take the saw blade off of the drive shaft and carefully pull it up and out of the saw table.
EN
A – Saw Blade Guard
B – Riving Knife
C – Bench Insert
Publicidad
