Beper 50.929B Manual De Instrucciones página 16

Steam iron Use instructions
The number of points on the thermostat (8) indicate the temperature from the lower one (•)
to the higher one (•••).The table is valid for fabrics and not for brilliant surfaces, with relief
printings or folds which must be ironed with low temperature.
Before using the iron, always make sure that the temperature of iron is adapted to the type
of fabric: wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a
low temperature (like synthetic fabrics) and always progress with the highest temperatu-
res..
When the cloth is made of several fabrics, set the temperature for the most delicate fa-
bric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing,
from lowest temperature, and then finding the temperature more adapted. If clothing be-
comes "brilliant", stop immediately in order to not damage it. Then start to iron it on the
back.
N.B. Pay attention to the symbol : that means that the fabric must not be iro-
ned.
STEAM IRONING
Before plugging the appliance, make sure the tank (2) is full of water.
Check the steam indicator (3) is on position « steam » to use steam function.
When used for the first time, press several times steam switch (4), in order to eliminate
dirt, residue from the manufacture.
Steam ironing is possible when setting the thermostat (8) on symbol (•) ; when the tempe-
rature increased the steam also increase until symbol max. (•••).
The light indicator (7) illuminate and when the soleplate is at good temperature switch
off.
Pressing the steam switch (4), steam function is activated.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If steam switch (4) is pressed before reaching the setting temperature, steam func-
tion won't work but only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of steam switch (4), by more than 5 se-
conds.
To obtain a non-stop steam, keep steam indicator (3) in position
16