cecotec CUMBIA CREMMAET COMPACTCCINO BLACK Manual De Instrucciones página 26

ENGLISH
Components Maintenance
Remove the brewing unit and wash it under running water from
Brewing unit the top, remove the coffee grounds from the surface of the
plunger filter. Clean the processing unit by hand every 3 days.
Do not wipe lubricating oil from the bottom and centre of the
processing unit. Do not wash it in the dishwasher.
Drip tray and Remove the drip tray and the waste container after each use,
waste container rinse under running water and wipe clean with a cloth.
Clean them at least every two days.
Water tank Rinse the tank under running water every 3 days.
Clean the coffee bean container weekly. Use a soft, dry cloth to
Coffee bean wipe oil/coffee grounds from the inside.
container/grinder If a large amount of coffee oil has remained in the coffee bean
tank, it means that a large amount of oil could be inside the
grinder: clean it.
To clean the bean container and the grinder, you can use a
grinder cleaner for coffee machines: place the cleaner inside the
container and brew an espresso with the maximum amount of
coffee.
Then remove the brewing unit and manually clean the residues
inside.
Open the right panel, remove the brewing unit, and clean the
Ground coffee ground coffee channel with a soft cloth on a weekly basis.
groove
Descaling
A. Pour the descalcifier into a container with clean water and wait for it to dissolve
completely.
B. Press and hold the menu icon and the standby mode will display the descaling icon.
C. Take out the water tank, pour the descaling product into it and add clean water until the
tank is completely full.
D. Press the OK icon to start descaling.
E. Once emptied, remove the water tank, and add clean water.
Press OK icon again and the machine will start the washing cycle.
F.
G. After the washing cycle has finished, the machine will return to the standby mode.
50
Sealing rings
Sealing rings are included with the coffee machine and brushes for replacing them in case
of wear. When they are replaced, you will notice unwanted coffee or water leaks. To replace
them, you can use any pointed tool to remove the old ones and place the new ones exactly in
the same position.
Cleaning the milk outlet
A metal brush specially designed for cleaning the milk outlet holes is included with the
brewer, the plastic brush, and the sealing rings, as the milk can dry out relatively easily and
clog the spout.
5. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If the appliance experiences a mechanical failure, please contact Cecotec's Technical Support
Service. If the problem persists, contact only authorised technicians, the supplier, or the
dealer.
No. Problem No. Possible cause
1 The control
panel display 1.1 The water tank is empty.
shows the water
tank icon.
It is necessary to
1.2 calibrate the water level
sensor.
CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
ENGLISH
Solution
Fill the water tank and insert
it into the machine.
When the machine is in
standby mode:
1.- Remove the water tank.
2.- Remove the sticker from
the reset button on the
water level sensor located
on the corner of the tank
housing. Then press and
hold the reset button for 6
seconds.
3.- Unplug the coffee
machine.
4.- Plug in and switch on
the brewer after 10 seconds.
Insert the tank once it has
been filled.
51