identités RS2 Manual De Instrucciones página 12

7. When both sides of the lower leg frame are securaly fastened
to the base, position the lower leg support assembly over the top
of the tubes
9. Move the lower leg support to the height
level required for the service user by
pulling the adjustment tape upwards until
the lower leg support reaches the correct
position, as shown by the numbers on the outside of the tube.
10. Attach the upper frame to the lower frame ensuring the spring
pin clicks into place to secure the upper and lower sections.
11. Unlock the brakes on the base plate. The Unit is now ready for
use.
USE
Version Juin 2023
8. Put the adjustment tape upwards to release the internal
pins. This will allow the lower leg feg support to move down
the tube until the pins reach the first positioning hole.
12