Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING
INSTALLATION
Place the bedside table on a clear surface and remove the packaging. Do not discard the packaging before the assembly is com-
pleted.
STEP 1
Place the table upside down on a flat surface as shown.
Insert the base above the table top frame, aligning the screw holes as shown
Insert the hexagon socket screws through the frame into the table top frame as indi-
cated.
Use the M8 hexagonal key to tighten the screws.
on the floor. Make sure that all parts are perfectly tightened before
using the bed table.
Remove the locking pin from the actutor.
Version Juin 2023
STEP 2
Place the U-shaped frame upside down over the base as indicated on the left. Screw the 3
screws through the plate, the base and the end of the base.
STEP 3
Turn the table over and place it
8
Publicidad
