Briggs & Stratton Generac Storm-Plus PowerBoss 5500 Manual De Instrucciones página 4

Your g enerator requires some assembly and
is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408.
IMPORTANT: Any attempt to run the unit before it has
been serviced with the recommended oil will result in an
engine failure.
REMOVE G EN ERATOR
FROM CARTON
• Set the carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
• Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,call
the generator helpline at 1-800-270-1408.
• The generator
• Generator and engine owner's manuals
• Locking 30Amp plug
• Engine oil
• Wheel kit
INSTALL WHEEL KIT
IMPORTANT:This wheel kit is not intended for
over-the-road use.
To installyour wheel kit you need the followingtools:
• Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows:
I. Placethe bottom of the generator cradle on a flat,
even surface.Temporarily place unit on blocks to ease
assembly.
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 2.
Cap Screw
\
\
Handle Assembly
\
\
Hex
Flat Washer
Mounting Leg J
Use Existing Fasteners
Axle
/
Wheel
O_
/
F
/
Retaining Pin
/
4