Metabo HPT WR36DA Manual página 14

English
(2) Turn the USB power switch ON (Fig. 8)
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB cable
USB port
(3) Connect the USB cable. (Fig. 8)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet and
the battery runs out of power, power output will stop
and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out, change
the battery or plug the power cord into an electrical
outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 8)
○ Remove the battery from the charger and place the
rubber cover over the USB port.
BEFORE USE
Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Selecting the socket matched to the bolt
Be sure to use a socket which is matched to the bolt
to be tightened. Using an improper socket will not only
result in insuffi cient tightening but also in damage to
the socket or nut.
A worn or deformed hex. or square-holed socket will
not give an adequate tightness for fi tting to the nut
or anvil, consequently resulting in loss of tightening
torque.
Pay attention to wear of socket hole, and replace
before further wear has developed.
2. Installing a socket
Select the socket to be used.
● Pin, O-ring type <WR36DA>
(1) Slide the O-ring out of the groove, then align the hole
of the socket with the hole of the anvil and insert the
anvil into the socket.
14
USB power
switch
USB power
indicator lamp
Fig. 8
Friction ring
O-ring
Hole of socket
(2) Insert the pin into the socket.
(3) While making sure that the pin doesn't fall, attach the
O-ring to the groove on the socket.
O-ring
Friction ring
Groove
Hole
Hexagonal
socket
CAUTION
● Please use the
which are listed in the operations manual and
metabo HPT's catalog. Accidents or injuries
could result from not doing so.
● Make sure to fi rmly install the socket in the anvil.
If the socket is not fi rmly installed it might come
out and cause injuries.
● When sliding the O-ring out of the groove of the
socket, be careful not to drop and lose the pin.
Hole of anvil
Fig. 9
Pin
Fig. 10
Fig. 11
Hole of anvil
Anvil
Fig. 12
designated attachments