Solution Tank Filling; Machine Operation - Clarke MA50 15B Instrucciones De Uso

A - ENGLISH

SOLUTION TANK FILLING

NOTE
The machine can be fi lled with a hose or bucket. Do not remove the Solution fi lter (21) while fi lling.
1. Fill water into solution tank (3) from the inlet (20) through hose or bucket.
2. Do not overfi ll the solution tank. It is best to leave a an inch from the top edge.
3. The water temperature must not exceed 40
CAUTION !
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
SOLUTION TANK DRAINING
NOTE
Solution tank should be drained and cleaned after each scrubber operation is completed.
1. Unscrew the drain cap (22) on the bottom of solution tank. The solution/water will fl ow freely into a bucket or fl oor drain.
2. Rinse the solution tank with clean water after every use. This will help prevent chemical buildup and clogging of the solution lid.
3. Replace the drain cap. (22)
RECOVERY TANK DRAINING
NOTE
Recovery tank should be drained and cleaned after each scrubber operation is completed.
1. Turn the latch (17) on the recovery tank. Remove the recovery tank from machine by grasping two grooves of tank and pulling up. Open the
lid (1) and overturn the recovery tank to drain the dirty water into a container, or unscrew the drain cap (23) to let water drain into a bucket.
2. Clean and Rinse the recovery tank with clean water after every use.
3. Re-place the recovery tank on the machine and turn the latch (17) to lock the tank in place.

MACHINE OPERATION

1. Set the handle to a comfortable height by pressing level. (25)
2. Lower the squeegee (33) onto fl oor by pulling down the lift handle. (26)
3. Turn on the main power switch. (47)
4. Turn on the brush motor switch (48) and the solution switch. (50)
5. Turn on the vacuum motor switch. (49)
6. If necessary, adjust the water fl ow by manually turning the ball valve. (31)
7. Pull one or both operating triggers. (24) The brush will spin & solution will begin to fl ow. Push the machine forward to start cleaning.
NOTE
If the battery indicator light (51) is green, the machine can be used. If it is yellow or red, the batteries must be charged.
CAUTION !
Before lifting the brush, turn off the main power switch. (47)
If the control panel (46) lights fl ash simultaneously, this indicates the machine is overloaded. Please turn off all the switches on the
control panel (46) to reset the machine. If problem persists, contact authorized service provider.
Operating machine with discharged batteries may cause harm to the batteries or to the machine.
A - 6
INSTRUCTIONS FOR USE
℃.
MA50 15B - 56091128 7/2014