Use; Before Machine Start-Up; Squeegee Installation; Solution Tank Filling - Clarke Vantage 17 Manual De Operacións

ENGLISH

USE

WARNING!
On some points of the machine there are some
labels indicating:
–
DANGER
–
WARNING
– CAUTION
– INFORMATION
While reading this Manual, the Operator must pay particular
attention to the symbols shown in the labels.
Do not cover these labels for any reason and immediately replace
them if damaged.

BEFORE MACHINE START-UP

To prepare the machine for operation, follow this procedure
before start-up.

Squeegee Installation

1. Install the squeegee (A, Fig. 5) and fix it by means of the
squeegee knobs (B), then connect the vacuum hose (C) to
the squeegee.

Solution Tank Filling

2. Fill the solution tank (A, Fig. 6) with a solution suitable for
the work to be carried out.
Do not fill the solution tank completely, leave few inches
from the edge.
Always follow the dilution instructions on the container label
on the chemical product used to create the solution.
The solution temperature must not exceed 100°F (40°C).
CAUTION!
Use only low-foam and non-flammable liquid
detergents, intended for automatic scrubber
applications.

Brush or Pad-Holder Installation

NOTE
According to the kind of cleaning to be carried out,
the machine can be equipped both with the brush (B,
Fig. 6) and the pad-holder (C) with pad (D).
3. Deactivate the transport/parking device (D, Fig. 5) by putting
it in position (E) after inserting the relevant pin (F).
4. Lift the brush cover (G, Fig. 5) by prying the handlebar (H).
5. Place the brush (B, Fig. 6) or the pad-holder (C) with pad (D)
under the cover.
6. Lower the cover (G, Fig. 5) by means of the handlebar (H).
7. Connect the extension (J, Fig. 5) with the power supply cable
(K). Connect the extension plug (L) to the electrical mains.
WARNING!
Before connecting the machine to the electrical
mains, make sure that the frequency and voltage
shown in the serial number plate/technical data
(M, Fig. 5) match the mains voltage.
8. Turn the brush/pad rotation switch (I, Fig. 5) to the "I"
position; then hook the brush/pad-holder by pressing for a
few seconds one or both switches (N, Fig. 5).
If the hooking operation is difficult, manually rotate the brush/
pad-holder counterclockwise (Fig. 7, next page).
12
Figure 5
Figure 6
Operator's Manual - Vantage 17 Cable