Mitsubishi Electric CITY MULTI PLFY-WL-NEMU-E Serie Manual De Instalación página 17

6. Installing the grille
3D i-see Sensor corner panel
Possible installation position 1
(Corner with the air outlet identifi cation marks □/□□□□)
3D i-see Sensor corner panel
Optional wireless signal receiver kit
Prohibited installation position
D
Fig. 6-10
C
D
Fig. 6-11
G E
F
Fig. 6-12
Drain piping of the main unit
A
B
C
E
F
G
F
G
E
A
B
H C D
A
B
3D i-see Sensor corner panel
Possible installation position 2
(Corner with the air outlet identifi cation marks □/□□)
3D i-see Sensor corner panel
Standard installation position (position when
shipped from the factory)
Water piping of the main unit
Fig. 6-9
6.5. Installation of 3D i-see Sensor corner panel (Fig.
6-9)
6.5.1. Standard position (Fig. 6-10) and position 2 (Fig. 6-11)
• Take the lead wires CN4Z (white, 4-pole) and CN5Y (white, 5-pole) of the 3D i-see
Sensor corner panel 4 from the side of the electrical box on the unit and make
sure to connect them to the connector of the controller board.
• Fix the excess portions of the lead wires using the clamp in the electrical box, mak-
ing sure that there is no slack in the lead wires.
• Put the cover back on the electrical box with 2 screws.
Note:
Make sure wires are not caught in the electrical box cover.
• Adverse procedure of "6.2. Preparing to attach the grille" will be taken for installing
the 3D i-see Sensor corner panel.
• The 3D i-see Sensor corner panel should be fi xed onto the grille 1 with screw 3.
6.5.2. Position 1 (Fig. 6-12)
• Take the lead wires CN4Z (white, 4-pole) and CN5Y (white, 5-pole) of the 3D i-see
Sensor corner panel 4 from the side of the electrical box on the unit and make
sure to connect them to the connector of the controller board.
• Route the lead wires through the bell mouth hooks and fi x the excess portions of
the lead wires using the clamp in the electrical box, making sure that there is no
slack in the lead wires.
• Put the cover back on the electrical box with 3 screws.
Note:
Make sure wires are not caught in the electrical box cover.
* Adverse procedure of "6.2. Preparing to attach the grille" will be taken for installing
the 3D i-see Sensor corner panel.
• The 3D i-see Sensor corner panel should be fi xed onto the grille 1 with screw 3.
[Fig. 6-10] [Fig. 6-11] [Fig. 6-12]
A Controller board CN4Z
B Controller board CN5Y
C 3D i-See sensor corner panel lead wire
D Clamp of electrical box
E Hole of grille (Pass the lead wire.)
F Screw 3
G 3D i-see Sensor corner panel
H Catch of bell mouth
en
15