Maytag MD-16 Guia Del Usuario página 6

Controlfeaturesand styling vary by model.
SELECT CYCLE
INTELLIDRY WRINKLE FREE FABRICS
WITH PRESS CARE
automatically senses the mois-
ture in the load and shuts off when the selected dryness
level is reached. It minimizes wrinkles of synthetic fabrics
such as acrylic, nylon, polyester or blends by providing an
unheated cool-down period at the end of the cycle. Simply
set the control to the desired dryness level (MORE DRY -
LESS DRY).The line between MORE DRY and LESS DRY
is the initial preferred setting for the majority of loads.
INTELLIDRY REGULAR
automatically senses the
moisture in the load and shuts off when the selected dryness
level is reached. This cycle isdesigned for loads such as tow-
els, underwear, t-shirts, jeans, etc. Set the control to the
desired dryness level (MORE DRY - LESS DRY). The line
between MORE DRY and LESS DRY is the initial preferred
setting for the majority of loads.
OF:F M@:R: _?RY
WRINKLE RELEASE will
release
wrinkles from items that are clean and dry
but slightly wrinkled, such as from a crowd-
ed closet, packed suitcase or from sitting in
the dryer too long after the end of the cycle.
It provides 10 minutes of heated tumbling
and 5 minutes of cool down tumbling with-
out heat.
DAMP DRY
is designed to "partially"
dry items. It provides approximately 20
minutes of heated tumbling and 5 minutes
of cool down tumbling without heat.
DRYELFABRICCARE (select
mod-
els) is designed for use on dry clean only
fabrics in combination with DryeI Dry Clean
Only Fabric Care product. Placing the con-
trol dial arrow at the DRYEL line will provide
the optimal amount of time needed to prop-
erly use DryeI. (For more information on
using the DryeI cycle, see page 7.)
TIME DRY/AIR FLUFF
may be
selected for any load ifthe IntelIiDrysensor
system is not desired. Set the control to the
desired number of minutes.
The dial can be turned in either direction to select a cycle. Once started, the dial will not advance at a specific rate during the
IntelliDry cycles.At first the dial may not advance at all.Toward the end of the cycle (when the load begins to dry) the dial will
advance at a more regular rate and much more quickly.This is normal operation.
5